Bench Top Temperature and/or Humidity Chamber (2-3°C/min)

NEW!!

The Burnsco BT 1.3P Benchtop chamber is manufactured to the highest of standards to provide superior performance. The chamber is ideal for testing small products over a wide range of applications. As with all our chambers it utilizes a Watlow controller and has both temperature to -70°C and humidity testing capabilities.

The chamber has been designed to occupy very little bench space while conveniently using a standard 110 Volt outlet. These power requirements ensure maximum flexibility. You will find it perfect for R&D and Production applications alike.

The unit is available for purchasing, renting and leasing.

Pricing Click here for pricing
Volume 1.3 FT³
Inner Dimensions (WxDxH) 16” x 12” x 12”
Outer Dimensions (WxDxH) 23” x 26” x 31” 29” x 26” x 31” 23” x 26” x 31” 29” x 26” x 31”
Temperature Range -30°C to 200°C -30°C to 177°C -70°C to 200°C -70°C to 177°C
Tolerance at the sensor (°C) ± 0.5°C
Humidity Range -- 20 to 95 % RH -- 20 to 95 % RH
Tolerance at the sensor -- ±4% RH -- ±4% RH
Heating Change Rate -20 °C to +85 °C within 30 minutes -40 °C to +85 °C within 35 minutes
Cooling Change Rate +85 °C to -20 °C within 40 minutes +85° C to -40 °C within 40 minutes
Live Load Capability 100 Watts@ 0 °C 100 Watts@ -40 °C
Controller Set point / Programmable PID Control
Refrigeration System Single Stage, Air or Water-Cooled
1@ 1/3 Hp 		Cascade, Air or Water -Cooled
2@ 1/3 Hp
Air Heaters 1 x 500 Watts
Humidity Heater -- 1 x 500 Watts -- 1 x 500 Watts
Supply Voltage 120V/1/60Hz
Full Load Amps 12 16 16 20
Drain 1/2"
D.I. Water Supply (25 psig max) -- 1/4" -- 1/4"
Weight (lbs) 180 200 210 230
  1. 20 °C ambient temperature required for assured performance.
  2. Humidity Range Shown Below (Live Load = 0 W).


  3. Based on a live load = 0 Watts and 0 lbs. equivalent mass of Al
Specifications Subject To Change without Notice
Download pdf version